Reported by:

worse blow jobs I ever had


								

								

the blower motor cylindrical fan on my furnace is the shittiest piece of SHIT THAT WAS EVER A PIECE OF FRICKING SHIT

EVERY YEAR WHEN IT GETS COLD IT SELF DESTRUCTS BECAUSE IT'S A FRICKAIO"HNGDSAN KLJM<M PIECE OF SSHITGSALDKEJHFTRKJ

ME AND QUEERIE BEEN SITTING AROUND HERE CHILLIN LITERALLY FOR LIKE A WEEK AT 50 DEGREES AMERICAN AND I FINALLY GET THE NEW OVERPRICED REPLACEMENT AND THE SHAFT BREAKS OFF IN THE FRICKING MIDDLE FML

NO REFUNDS FROM THIS SHITTY FRICKING SHIT SITE WWW.PARTSSOURCE.COM FRICK THIS SITE.

picture guide:

1- original OEM blower motor fan that exploded like 5 years ago and I overpayed some r-slurred hvac butthole to replace the whole GOT DARN thing. I didn't really even understand what had happened then except I found evidence later that the fan had fricking exploded as there were the fanblades scattered in the bottom of the furnace floor.

https://i.rdrama.net/images/17317240315058892.webp

2- piece of shit replacement OEM spun itself off the shaft nearly destroying the whole case of the new blower motor replacement from year prior and chewed itself to death before any of the so called safety features did shit

https://i.rdrama.net/images/17317240305645669.webp

3- SAME THING AS ABOVE, LASTED 1 YEAR, SHAFTED ITSELF

https://i.rdrama.net/images/17317240324532351.webp

4- PIECE OF FRICKING SHIT REPLACEMENT OEM LITERALLY BROKE FROM THE SHAFT AS I WAS TRYING TO REPLACE IT, SEATED WITH ONLY GENTLE PRESSURE AND THE MIDDLE KEYSLOT SHAFT COMPLETELY TORE OUT FML. GONNA TRY TO SALVAGE WITH EPOXY AS PICTURED USING WASHERS TO TRY AND REINFORCE BUT MY HOPES ARE LOW. I ALREADY ANTICIPATED THIS WAS A GONNA BE A TEMP SOLUTION BUT THE REAL PART FROM AMAZON ISN'T GONNA BE HERE FOR ANOTHER WEEK :marseyraging:

https://i.rdrama.net/images/17317240286986794.webp https://i.rdrama.net/images/17317240296150534.webp

The motor/casing and everything else is LITERALLY FINE and TRUE, is all just this GOT DARN PLASTIC SHIT FAN that refuses to STAY PUT and instead is designed to shit the bed even though I change filters every 4-6 months and use the light filters to reduce wear on the system.

!homeowners wish me luck, if this or the next replacement fails I'm ngmi

:fffffffuuuuuuuuuuuu#:

53
Jump in the discussion.

No email address required.

I was about to tell you guys about the worst bjs but alas this is some @SpookFatigue shit

Jump in the discussion.

No email address required.

Reported by:
  • DickButtKiss : Smoke ciggarettes and cigars, they'll keep your blood moving when ur body starts to shutdown

please do I need something to distract me until the booze warms my blood

Jump in the discussion.

No email address required.

Reported by:

she started biting, I had to show her how to do it on fricking xhamster

so many indian woman don't know about bjs, but I am watching pacific rim

Jump in the discussion.

No email address required.

:#mjlol:

Jump in the discussion.

No email address required.

!kino this neighbor film shaming me

Jump in the discussion.

No email address required.

I don't get it :marseysad:

Jump in the discussion.

No email address required.

https://media.tenor.com/wFOq9TrnBxgAAAAx/you-wouldnt-get-it-joker.webp

Jump in the discussion.

No email address required.

but I am watching pacific rim

:marseyxd: next time just gib her the ol' pacific rim job to set the bar high, brother

:marseyslurpfast:

Jump in the discussion.

No email address required.

im in a happy relationship :marseycool:

Jump in the discussion.

No email address required.

Dont hes indian, nothing over there counts

Jump in the discussion.

No email address required.

its all पाप/अधर्म/अशुद्ध/निषेध/दुराचार gabagool :marseychefkiss:

Jump in the discussion.

No email address required.

what lang is this?

Jump in the discussion.

No email address required.

Italian!

Jump in the discussion.

No email address required.

That's what I wanted to hear :marseygossipsmug:

Jump in the discussion.

No email address required.

Scumbag HVAC Gremlin:

>whistles yep, 's on account of it being an old piece of shit and probably dusty too. Too much trouble to clean believe me, it won't last long. I can give you a quote on a new furnace when I get back to the shop, probably be about 12k but we give you a warranty and everything. it's a good deal

Jump in the discussion.

No email address required.

RIGHTIHATETHEMSOMUCH :marseyaaatremble: THEY HAVE A SHITTY MONOPOLY ON FAST PARTS ACQUIREMENT

Jump in the discussion.

No email address required.


https://i.rdrama.net/images/17191743323420358.webp

Jump in the discussion.

No email address required.

Good Simpsons makes me sad that it's over

Jump in the discussion.

No email address required.

3d print a new one

But seriously that squirrel cage looks tiny.


https://i.rdrama.net/images/17191743323420358.webp

Jump in the discussion.

No email address required.

the motor literally runs on regular AC power at one speed, on or off, so I'm close to just rigging up my dust blower

https://i.rdrama.net/images/17317252629099638.webp

into the same getup with a few tubes and hose clamps I stg because its basically all metal and uses the same power and should be heat resistant enough to move all the carbon monoxide outside, I think

:marseygas#:

Jump in the discussion.

No email address required.

Is this like a Lennox Pulse furnace or something? Seriously it looks too small to be the whole-house blower

Though measuring mine, it's about 12 inches

https://i.rdrama.net/images/17317264367663863.webp


https://i.rdrama.net/images/17191743323420358.webp

Jump in the discussion.

No email address required.

much smaller, blower wheel is only 4.75 inches

https://i.rdrama.net/images/17317268219487345.webp

Jump in the discussion.

No email address required.

I don't understand. Do you live in an abandoned shack? Is this a purge blower?

I have two camper air conditioners sitting in my garage. Their blowers are 8" in diameter.

https://i.rdrama.net/images/1731727438365965.webp


https://i.rdrama.net/images/17191743323420358.webp

Jump in the discussion.

No email address required.

there's a much larger internal fan that powers the entire setup, this one is just purely for the exhaust from gas heat :marseythumbsup:

Jump in the discussion.

No email address required.

ok good.

then yeah, take a blower or shopvac and hook it up to the vent outside your house


https://i.rdrama.net/images/17191743323420358.webp

Jump in the discussion.

No email address required.

I've somehow neglected using my heater every year miraculously without my pipes bursting.

You should get matching snuggies for yourself and queerie.

:#marseyqueerie:


https://i.rdrama.net/images/17308113587099795.webp

Jump in the discussion.

No email address required.

your a masochist :marseyfrozen#:

we got blankets for days thankfully but I am really glad for once that xhes so fat and unable to lose weight and that he likes to snuggle and share the cat heat

Jump in the discussion.

No email address required.

Everytime my furnace comes on it makes a horrible sound. It was like that last winter too. Still works though LOL!

Jump in the discussion.

No email address required.

ORDER REPLACEMENT FANS FOR YOUR EXHAUST BLOWER MOTOR BEFORE ITS TOO LATE

SAME SHIT THAT HAPPENED TO ME X4 WHERE THE HARMONICS EQUALIZED ONCE HEAT WENT CRIT, BUT THEY SHIT THE BED SOON AFTER YOU START HEARING THAT!

the fans in all fairness cost $20, where as if it destroys your motor or case will cost $200. So I'm frustrated but still saved like $1000-5000 by just dealing with this shitty design and throwing shitty poorly designed parts at it

Jump in the discussion.

No email address required.

That was quick

!tradies What's wrong with my shit?

Jump in the discussion.

No email address required.

It's found out you're gay

Jump in the discussion.

No email address required.

The jig is up!

Jump in the discussion.

No email address required.

Do you know what that is and how I can fix it?

Jump in the discussion.

No email address required.

hard to say, but it could just be the fan assembly loose or a stray piece rattling the innards until it heats up and then stays within it's lane

Jump in the discussion.

No email address required.

Are you an HVAC guy?

Jump in the discussion.

No email address required.

no neighbor I'm a nurse

Jump in the discussion.

No email address required.

For real? A racist nurse? Interesting.

Jump in the discussion.

No email address required.

yes but my hatred of white women would never carry over to contaminate my professional ethics

Jump in the discussion.

No email address required.

I'll try to take a video next time it happens

Jump in the discussion.

No email address required.

How are those bearings lubricated?

Jump in the discussion.

No email address required.

sealed :marseywholesome: :marseydepressed:

Jump in the discussion.

No email address required.

Get a metal one instead, obviously plastic isn't suitable

Jump in the discussion.

No email address required.

did but it's taking forever to deliver :(

Jump in the discussion.

No email address required.

I don't see what the big deal is tbh.

>oh nooo queerie and I are gonna need to cuddle for warmth

:marseyq#ueerielove::marseyq#ueerielove::marseyq#ueerielove:

Jump in the discussion.

No email address required.

Best blowjob I ever had. I'm this really nervous kid, I've never done this before. This older girl with more experience tells me to just relax...

...and she blows some kind of powder on my face before I go on stage. And smiles and tells me to go on stage. She was the best.

:marseyexcited:

Jump in the discussion.

No email address required.

https://i.rdrama.net/images/17076979252020252.webp

Jump in the discussion.

No email address required.

Link copied to clipboard
Action successful!
Error, please refresh the page and try again.