Unable to load image

Rec soldering iron/equipment

I want to soup up an old butt tube ham radio I found on Craigslist and figured I should get a better soldering station rather than get something cheap. I’m ok with soldering I just haven’t done it in 15-20 years. I was thinking of getting this

YIHUA 853D USB 3A-Three Cowtools- Soldering Station, Hot Air Rework Station and Power Supply 0~3A, 0-15V with output and test modes. Also ºC/°F display, Digital Cal, Sleep Function https://a.co/d/4Yk6tY5

Because it’s a heat gun and adjustable and has leads for continuity testing and all sorts of stuff

Is this good? Idk

10
Jump in the discussion.

No email address required.

Theres always the pinecil or the ts-100, which it is a clone of. Honestly, you don't need much to get started. The most basic setup that will handle most problems is a pen, flux, lead solder, and desoldering wick or pump. Maybe helping hands if you need it. For flux I'd recommend to stay away from rosin flux because youll have to wash the board after since it's conductive. Solder pens are neater and less clean up, just need a brush with some alcohol to get it off.

Jump in the discussion.

No email address required.



Now playing: Aquatic Ambience (A Hint of Blue remix) (DKC).mp3

Link copied to clipboard
Action successful!
Error, please refresh the page and try again.